search Custom MMIC
Custom MMIC

News

LNA MMIC Offers a Noise Figure of 1.5 dB from 6 to 18 GHz

Posted on Thursday, June 07, 2012
LNA MMIC Offers a Noise Figure of 1.5 dB from 6 to 18 GHz

LNA MMIC Offers a Noise Figure of 1.5 dB from 6 to 18 GHz  – Custom MMIC is offering two new devices from its growing MMIC design library. The CMD157 (die) and CMD157P3 (packaged) are GaAs MMIC low-noise amplifiers (LNAs) for applications from 6 to 18 GHz. These broadband devices each boast an impressively low noise figure of 1.5 dB, deliver greater than 25 dB of flat gain, and have a corresponding output 1 dB compression point of +10 dBm.

Both the CMD157 and the CMD157P3 are 50 Ohm matched designs, thus eliminating the need for external DC blocks and RF port matching. The CMD157 is suitable for chip-and-wire applications, whereas the CMD157P3 is housed in a leadless RoHS compliant 3x3 mm plastic surface mount package. The amplifiers are biased with a single positive voltage of +3.0 V @ 52 mA. RF power can be applied at any time.

These LNAs are much smaller, lower-cost alternatives to hybrid amplifiers in this frequency range. Ideally suited for broadband EW and communication systems, where small size and low power consumption are needed, the CMD157 and the CMD157P3 can also be used in low noise downconverters, microwave radio receiver systems, and radar receivers. For full datasheets on the CMD157 and CMD157P3 GaAs MMIC LNA, visit: http://custommmic.com/Product-Library/Amplifiers/

Custom MMIC

300 Apollo Drive
Chelmsford, MA 01824
Phone: 978-467-4290
Fax: 978-467-4294

Terms and Conditions

©2006-2017 Custom MMIC
All rights reserved.

Get our Updates:

Stay informed of new products:

Custom MMIC

300 Apollo Drive
Chelmsford, MA 01824
Phone: 978-467-4290
Fax: 978-467-4294

Terms and Conditions

©2006-2017 Custom MMIC
All rights reserved.